How To Roll A Joint:
A Step-by-Step Guide

How To Roll A Joint:
A Step-by-Step Guide

Duration:

5 min

Created:

July 31, 2018

Category:

How To’s

HIGHTIMES

www.hightimes.com

Ultimate
beginner’s guide

Learning how to roll a joint is a vital key to any cannabis consumer’s skills set. It’s the simplest method and you’ll come in clutch anytime there’s weed, no pipe and nobody else that can roll.

Before you get rolling you’ll want to pick a pack of the best rolling papers for you. That can mean unbleached or made of hemp to keep things purely cannabis. Thin papers make it easier to taste your weed but they’re a little harder to roll.

Step 1: Break It Down

The first step to learning how to roll a joint is breaking it down. Get your weed into a consistency that can be easily smoked. Sure, you can just poke a hole in a sticky nug and smoke it whole without a pipe or papers. However, you’ll be stressing your lungs just to get enough smoke to get high.

Step 2: Prepare
The Filter (optional)

Rip a piece of filter paper and fold one end into. Then, roll the remaining filter paper tightly around the W. You can get creative and make it whatever shape you want, as long as there are no wide gaps in it.

The filter acts as a guard preventing any loose weed from flying into your mouth. It also makes it easier to smoke the joint to the end without having resin close the mouthpiece or burning your fingers.

Step 3: Put It On Paper

The best way to make something official is by putting it on paper. This is especially true when it comes to joints. Without the paper, there is no joint. Before you add the weed you can pick a side for your filter if you plan on adding one.

There are two styles of joint that you commonly see rolled: the pinner and the bat. You must pick one before putting your weed in.

Styles of Joint

Pinners are straight cigarette-looking joints. Bats are in the shape of a cone with one end much larger than the other. The benefit of a pinner is everyone gets a pretty even sized hit during the puff, puff pass rotation. It’s also a bit stealthier than a bat.

Bats are great for solo smokes. The first few puffs are all weed and hardly any paper so you can really taste the flower you’re using. The end also has less weed in it so you won’t feel as guilty if you toss the roach.

Step 4: Tuck

This step is usually what throws people off. Before you become a dependable joint roller you’ll need to master the art of the tuck.

The trick is to start at the end with the filter in it and tuck the paper around that then move your thumb to the other side while tucking the rest.

Step 5: Roll & Lick

Once you’re confident in your tuck, roll it until you’re close to the glue-end. Add a little bit of moisture and pat it down on one side. Slowly work your way across the rest of the joint until it is all sealed up.

You’ve made it through the hard part, you could smoke it as is if you want but there are a couple of additional steps to learning how to roll a joint. First, make sure it’s tightly rolled. You can use something small to push the weed in from the end you’re lighting.

Step 6: Twist & Spark

The final step depends on when you’re smoking the joint. If you’re taking it to go or saving it for later, you’ll definitely want to twist the end shut.

If you packed it down, the end opposite of the filter should be all paper and no weed. You can add a tiny bit of moisture to it and twist the paper end shut.

If you can spark up right where you rolled it then go ahead. There’s no need to twist.